Foam Stress Tester  is used to test the stretch, compress, bend, low cycle fatigue of  metal and nonmetal, high polymer material etc. Foam Stress Tester can be programmed according to customer's requirement base on standard GB\ISO\ASTM\JIS\EN etc.It can get the maximum Test force, breaking power, yield strength, tensile strength, compression strength, flexural strength, Modulus of Elasticity, Elongation, Specified elongation stress, Set elongation stress etc. Parameters.

1. Automatic zeroing:the computer starts to test,system clear automatically.

2. Automatic reset:break test,system will go back to the initial position automatically.

3. Automatic shift:according to the different loading, you can switch different degree to ensure measurement accuracy

4. Adjust speed:adjust speed test according to different specimen.

5. Indicating value verify: system enables display the accurate calibration of force

6. Control method:select the test force,test speed,displacement,strain etc.test method.

7. Multipurpose:various sensors are available,can realize multipurpose in one tester.

8. Curve ergodic:after the test,you can find out any curve point value and transformative data and analysis it.

9. Display: dynamic display of the data and curve test process

10. Result:The test result can be accessed.analysis the data curve.

11. Limit: cell-type and machinery limit.

12. Overload:automatic shutdown when exceed the rated value..

technical parameters:

The maximum test capacity:10KN 20KN 30KN 50KN 100KN

Indicating value relative error at most: ±1%

Displacement relative error: ±1%

Transformation relative error: ±1%

Test range: 1%-100%,no difference between any degree

Displacement speed: 0-500mm/min, displacement speed

Valid test stroke: 0-730mm

Valid test width: 360mm

Resolution ratio: 1/200000

Control Method:strength,shift, transformation,

Power supply: 220V 50HZ

Foam Stress Tester dimensions: 360*380*1650mm

Standards:

GB/T10807-89,ISO 2439-1980

GB, ISO, ASTM, JIS or EN standard also can be adjusted according to customer's requirement